Intergum

Application – for a gun

• The surface to be covered must be clean, dry, dust-free, degreased and cleaned of rust.
• Shake the package before use.
• Intergum agent can be applied with an air gun at a pressure of 3 – 6 bar.
• The optimal spray distance is about 30 cm.
• If a thicker layer is recommended, it is recommended to dry the coating before applying the next layer.
• Clean contaminated surfaces and fixtures with solvent.

DO NOT USE ON TEFLON

Note: for safety purposes, always follow the data on the Material Safety Data Sheet for the product.

Dry to the touch*: 120 -180 minutes at 600 μm wet film.
Completely dry*: 4 – 6 hours at 600 μm wet film
Removal method: fresh coating – solvent, cured coating – mechanical.
* at 20°C and 65% relative humidity.

Application – for a brush

• The surface to be covered must be clean, dry, dust-free, degreased and cleaned of rust.
• Shake the package before use.
• Intergum can be applied with a brush or spatula.
• If a thicker coat is recommended, it is advisable to dry the applied coat before applying the next coat.

DO NOT USE ON TEFLON

Note: For safety purposes, always follow the data on the Material Safety Data Sheet for the product.

Dry to the touch*: 90 – 120 minutes at 500 µm wet film.
Completely dry*: 10 – 12 hours at 500 µm wet film
Removal method: fresh coating – solvent, cured coating – mechanical.

* at ±20°C and 65% relative humidity.

Application – spray

• The surface should be degreased, dry, cleaned of old varnish and rust and then smoothed with sandpaper.
• The best temperature for applying the spray is 15 – 25°C.
• Before application, shake the can for about 2 minutes and try the spray on a cardboard box.
• Apply several coats holding the aerosol at a distance of 25÷30 cm from the painted surface.
• After finishing the application, it is recommended to set the aerosol with the valve down and press the button releasing the contents for about 5 seconds – this will improve the re-use of the product and preserve its existing properties, as well as protect the nozzle from possible clogging.

Note: for safety purposes, always follow the data on the Material Safety Data Sheet for the product.

Drying time*: Approximately 60 minutes (at room temperature).

*Drying time depends on temperature, humidity and coating thickness.