Multi

Multifunctional polyester putty

Variants

ColourArt. No.CapacityQuantity per carton
light beige165091 l10

Gloss grade

matt
Multi
New

Technical documentation

Description

Lightweight, multifunctional polyester putty designed for quick automotive repairs. The product combines the features of the filling and finishing putty. It is characterized by a creamy consistency , very good adhesion to various substrates, easy application and a very smooth surface after sanding.

Advantages

  • Very smooth surface after sanding.
  • Low specific weight.
  • Easy to mix and apply.
  • Very easy to sand.

Substrates

The product has very good adhesion to various surfaces. It can be applied over:

  • Bare steel and aluminum after flatting and degreasing.
  • Zinc coated steel after flatting and degreasing.
  • Sanded glass fibre (GFK/GRP), polyester putties, acrylic and epoxy primers and existing coatings in good condition.

We recommend sandpaper with gradations: P80÷P120.

Caution: Do not apply the putty directly on the reactive primers, 1K acrylic and nitrocellulose products.

Important informations

  • Przetrzeć odtłuścić

    degrease

  • Mieszanie wg wagi

    Mixing ratio by weight
    100 : 2

  • Czas życia

    Pot life
    4 ÷ 6 min. / 20°C

  • Czas utwardzania

    Hardening time
    20 ÷ 30 min. / 20°C

  • Szlifowanie

    P120 ÷ P180
    P220 ÷ P320

Application process

  • Zastosowanie
  • Use

    For quick car repairs.

  • Mieszanie wg wagi
  • Mixing ratio by weight

    Putty: 100
    Hardener: 2

    Stir thoroughly until achieving homogenous paste. Be careful not to create air inclusions.

  • Czas życia
  • Layer thickness

    Putty can be applied in several thin coats. After each of them the product should be cured. Do not exceed the thickness of 3 mm.

    Pot life is 4÷6 minutes at 20°C.

  • Czas utwardzania
  • Hardening time

    20÷30 minutes at 20°C.

    Temperature below 20°C significantly increases the hardening time.

  • Szlifowanie
  • Sanding

    Coarse sanding (dry): P120÷P180.
    Finish sanding (dry): P220÷P320.

  • Suszenie promieniem IR
  • IR drying

    5÷7 minutes of short waves, , depending on the layer thickness and the type of radiator.
    Do not exceed 60°C.
    Use as recommended by the equipment manufacturer. Wait about 5 minutes before starting the heater drying.

  • Informacja
  • Further work

    Polyester putties can be over coated with:

    • 2K polyester putties
    • 2K polyester spray fillers
    • 2K acrylic primers
    • 2K epoxy primers
  • Informacja
  • General notes
    • Excessive amount of hardener will cause problems with bleaching of the basecoat/topcoat!
    • When working with 2K products, it is recommended to use personal protection equipment. Protect the eyes and respiratory system.
    • The rooms should be well ventilated.
    • Clean the guns and equipment immediately after use.

    Caution: To maintain safety, always follow the instructions given in the MSDS for the products

Ask about this product



       
    See also other products
    Wyjście 
    Go to top