Fine

Finishing polyester putty

Variants

ColourArt. No.Capacity Quantity per carton
white1050400 g18
white1156 1 kg10
white1154 1,8 kg10

Gloss grade

matt
Fine

Technical documentation

Video

Description

Bicomponent finishing poliester putty with high adhesion to different substrates. Allows for application of thin layers, removes holes, scratches and smaller imperfections. Leaves the surface perfectly smooth after sanding.

Advantages

  • Very good adhesion to metals.
  • Easy to mix and apply.
  • Smooth surface after sanding.

Substrates

The product has very good adhesion to various substrates. It can be applied over:

  • Steel and aluminum after flatting and degreasing.
  • Zinc coated steel after flatting and degreasing.
  • Sanded glass fibre (GFK/GRP), polyester putties, acrylic and epoxy primers and existing coatings in good condition

We recommend sandpaper with gradations: P80÷P120.

Caution:  Do not apply the putty directly on the wash primers, 1K acrylic and nitrocellulose products.

Important informations

  • Przetrzeć odtłuścić

    degrease

  • Mieszanie wg wagi

    Mixing ratio by weight
    100 : 2

  • Czas życia

    Pot life
    4 ÷ 7 min. / 20°C

  • Czas utwardzania

    Hardening time
    20 ÷ 30 min. / 20°C

  • Szlifowanie

    P80 ÷ P120
    P120 ÷ P320

Application process

  • Zastosowanie
  • Use

    Finishing polyester putty for car repairs.

  • Mieszanie wg wagi
  • Mixing ratio by weight

    Putty: 100
    Hardener: 2

    Stir thoroughly until achieving homogenous paste. Be careful not to create air inclusions.

  • Czas życia
  • Layer thickness

    Putty can be applied in several thin coats. After each of them the product should cure. Do not extend thickness of 3 mm.

    Pot life is 4÷7 minutes at 20°C

  • Czas utwardzania
  • Hardening time

    20÷30 minutes at 20°C.

    Temperature below 20°C significantly increases the hardening time.

  • Szlifowanie
  • Sanding

    Coarse sanding (dry): P80÷P120,
    Finishing sanding (dry): P120÷P320.

  • Suszenie promieniem IR
  • IR Drying

    5÷7 minutes of short waves, depending on the layer thickness and the type of radiator.
    Do not exceed the temperature of 60°C.
    Use as recommended by the equipment manufacturer.

    Caution: Wait about 5 minutes before the IR drying process

  • Informacja
  • Further work

    Polyester putties can be over coated with:

    • 2K polyester putties,
    • 2K polyester spray fillers,
    • 2K acrylic fillers,
    • 2K epoxy fillers.
  • Informacja
  • General notes
    • Excessive amount of hardener will cause problems with bleaching of the top coat!
    • The rooms should be well ventilated.
    • Tools should be washed directly after application.
    • Use personal protection equipment during the 2K products application. Protect the eyes and respiratory system.

    Caution: To maintain safety, always follow the instructions given in the MSDS for the products.

Ask about this product



    

    Related products

      
    See also other products
    Wyjście 
    Go to top