Atlantic

Very lightweight and filling polyester body filler

Variants

Art. No.	Color	Capacity	Quantity per carton
8531	mustard	1000 ml	10
15330	mustard	3 l	4

Gloss grade

matt

Technical documentation

Video

Description

High-quality lightweight polyester body filler designed for filling medium-sized defects and leveling surfaces during car body repairs. Characterized by its low viscosity and exceptionally fluid consistency. Suitable for application on large surfaces and in thin layers with good leveling effect.

Advantages

Easy spreading
Very low density allowing application on large surfaces.
Very easy mixing and application process.
Exceptional sanding quality.

Substrates

The product has very good adhesion to various substrates. It can be applied over:

Bare steel and aluminum after flatting and degreasing.
Zinc coated steel after flatting and degreasing.
Sanded glass fibre (GFK/GRP), polyester putties, acrylic and epoxy primers and existing coatings in good condition.

Caution: Do not apply the putty directly on the reactive primers, 1K acrylic and nitrocellulose products.

Important informations

degrease
Mixing ratio by weight
100 : 2
Pot life
5 ÷ 7 min. / 20°C
Hardening time
20 ÷ 30 min. / 20°C
P100 ÷ P180
P180 ÷ P280
Caution: Stir well before using.

Use
Very lightweight polyester body filler for car body repairs.

Mixing ratio by weight
Body filler: 100
Hardener: 2
Stir thoroughly until a homogenous paste is obtained. Be careful not to create air inclusions.

Layer thickness
Putty can be applied in several thin coats. After each of them the product should cure. Do not exceed the thickness of 3 mm.
Pot life is 5÷7 minutes at 20°C.

Hardening time
20÷30 minutes at 20°C
Temperature below 20°C significantly increases the hardening time.

Sanding
Coarse sanding (dry): P100÷P180,
Finish sanding (dry): P180÷P280.

IR Drying
5÷7 minutes of short waves, depending on the layer thickness and the type of radiator.
Do not exceed the temperature of 60°C.
Use as recommended by the equipment manufacturer.
Caution: Wait about 5 minutes before the IR drying process

Further work
Polyester body fillers can be over coated with:
- 2K polyester putties.
- 2K polyester spray fillers.
- 2K acrylic primers.
- 2K epoxy primers.
- 2K wash primers.

General notes
- Excessive amount of hardener will cause problems with bleaching of the topcoat!
- When working with 2K products, it is recommended to use personal protection equipment. Protect the eyes and air ways.
- Clean the guns and equipment immediately after use.
- The rooms should be well ventilated.
Caution: To maintain safety, always follow the instructions given in the MSDS for the products.