UBS Anti-Gravel with structure

Agent for car body protection

Variants

Colour	Art. No.	Capacity	Quantity per carton
black	300002290	500 ml	12

Gloss grade

matt

Technical documentation

Description

Quick-drying agent based on synthetic resins designed for the protection of car bodies. Provides long-term protection against the chemical and mechanical factors (including harmful effects of fuel, oil, water and salt) for the front and rear of the car bodies, car sills, wheel housings etc. It is characterized by very good adhesion, creates visible structure, does not contain asphalts and bitumen. Can be overcoated with any lacquer systems*.

* Compatibility test is recommended.

Usage

The best results are achieved by applying the product at room temperature. Room temperature and the temperature of the product should be the same.
Shake before using for 2 minutes and try it on a cardboard.
During lacquering hold aerosol with 25÷30 cm of distance from the surface.
Apply 2 or 3 single layers with an interval of 5 – 10 minutes. Shake aerosol before applying each layer.
Clean the spray nozzle after use! – Hold the can with the valve pointing downward, press the button emptying the content for about 5 seconds.

Caution: For safety reasons always follow the information provided in the Material Safety Data Sheet.

Can be covered with any varnish*.

Drying time at 20°C: 2 – 3 hours

* Compatibility test is recommended.
**Drying time depends on air temperature, humidity and thickness of the layer

Substrates

Product has very good adhesio to various substrates. It can be applied over:

Polyester laminates
Polyester putties
Epoxy primers
2K Acrylic primers
Steel, galvanized steel and stainless steel
Aluminium Wash primer
Plastic

Surface preparation
- Polyester laminates should be degreased, sanded dry (P80-P120) and degreased again.
- Polyester body fillers and putties should be sanded dry (P120).
- Primers should be degreased, sanded dry (P220 – P280) and degreased again.
- Steel should be degreased, sanded dry (P80 – P120) and degreased again.
- Stainless steel surface be degreased.
- Aluminium and galvanized steel should be degreased, dulled with the abrasive cloth
  and degreased again.
- Old paint coatings should be degreased, sanded dry (P220 – P280) and degreased again.
- Plastics should be washed with water and detergent, matted with an abrasive cloth and degreased again.
- In the case of plastic, it is recommended to heat the element at 50 ° C before starting application, this will facilitate the removal of silicone from its surface.