Soft

Soft and filling polyester putty

Variants

Colour	Art. No.	Capacity	Quantity per carton
cream-colored	1131	250 g	12
cream-colored	1109	400 g	18
cream-colored	1127	1 kg	10
cream-colored	1108	1,8 kg	10
cream-colored	1248	4,3 kg	4

Gloss grade

matt

Technical documentation

Video

Description

2-component soft sanding and high filling polyester putty designed for car repairs. Recommended for filling large dents and holes. Can be applied in thick layers with no sagging. Due to its flexibility, it is perfect for creating shapes and filling dents on surfaces with complex contours.

Advantages

Easy to mix and apply.
Proper hardness with good elasticity.
Good sanding properties.

Substrates

The product has very good adhesion to various surfaces. It can be applied over:

Bare steel and aluminum after flatting and degreasing,
Zinc coated steel after flatting and degreasing,
Sanded glass fibre (GFK/GRP), polyester putties, acrylic and epoxy primers and existing coatings in good condition,
Well sanded old and factory top coats.

We recommend sandpaper with gradations: P80÷P120.

Caution: Do not apply the putty directly on the reactive primers, 1K acrylic and nitrocellulose products.

Important informations

degrease
Mixing ratio by weight
100 : 2
Pot life
4 ÷ 7 min. / 20°C
Drying time
20 ÷ 30 min / 20°C
P80 ÷ P120
P120 ÷ P320

Use
Soft sanding polyester putty for car repairs.

Mixing ratio by weight
Putty: 100 parts
Hardener: 2 parts
Stir thoroughly until achieving homogenous paste. Be careful not to create air inclusions.

Layer thickness
Putty can be applied in several thin coats. After each of them the product should cure. Do not exceed the thickness of 5 mm
Pot life is 4÷7 minutes at 20°C

Hardening time
20÷30 minutes at 20°C.
Temperature below 20°C significantly increases the hardening time.

Sanding
- Coarse sanding (dry): P80÷P120,
- Finishing sanding (dry): P120÷P320.

IR drying
5÷7 minutes of short waves, depending on the layer thickness and the type of radiator.
Do not exceed the temperature of 60°C.
Use as recommended by the equipment manufacturer.
Caution: Wait about 5 minutes before the IR drying process.

Further work
Polyester putties can be over coated with:
- 2K polyester putties.
- 2K polyester spray fillers.
- 2K acrylic fillers.
- 2K epoxy fillers.

General notes
- Excessive amount of hardener will cause problems with bleaching of the topcoat!
- When working with 2K products, it is recommended to use personal protection equipment. Protect the eyes and respiratory system.
- Clean the guns and equipment immediately after use.
- The rooms should be well ventilated
Caution: To maintain safety, always follow the instructions given in the MSDS for
the products.