C88 Premium Speed HS 2:1

Use

Fast car body repairs that required durable finish.

Mixing proportion per volume

Clearcoat: 2
Hardener: 1
Thinner:
– with standard hardener 0-5%
– with fast hardener 10%

* it is not recommended the use of accelerators and fast express thinners.

Spraying viscosity

15÷17 seconds at 20ºC DIN4

Pot life for the mixture

About 2,5 hours at 20ºC

Gun parameters

Number of layers: 2 full layers; about 50÷60 µm of dry coating.
RP Nozzle: 1,3÷1,4mm; Pressure: 2,0÷2,2 bar.
HVLP Nozzle: 1.3÷1,4mm; Inlet Pressure: 2,0 bar.

Caution: Follow the recommendations of the equipment manufacturer.

Flash off time

Between layers: about 4÷5 min.
Before baking: 10 min.

*Flash off time depends on the type of painting booth.

Drying time for STANDARD hardener

Dust dry: 30 min./20°C, 10 min./60°C
Touch dry: 2,5 godz./20°C, 15 min./60°C
Ready to use: 8 godz./20°C, 15 min./60°C+3 godz./20°C
Final drying: 7 dni/20°C, 15 min/60°C+3 dni/20°C

* Temperatures below 20°C significantly increase the drying time.

IR Drying

10÷15 minutes under short wave depending on the total thickness and type of radiator.
Do not exceed maximum temperature of 60°C.
Use according to the recommendations of the equipment manufacturer.
Wait about 10 minutes before starting IR drying.

Performance

1 liter of the mixture is enough to paint 8÷10 m2 of surface with a layer thickness of 60 μm.

Shading

Make sure you have covered all the surface with the clear coat. You should only shade the surface that has been covered and treated. Use InterTroton FADE OUT THINNER to clean any dust or dirt from the surface and to level out the optical gloss differences between the older and new applied coating.

Polishing and eliminating defects

Usually polishing is unnecessary, as the C18 VHS Clear Coat 2:1 gives the surface a perfect finish immediately after application. However, if some dirt inclusions appear, we recommend removing them and then polishing the surface with an abrasive compound.

General notes

• Do not exceed recommended doses of the hardener!
• The best repair results can be achieved by painting at room temperature. The temperature in the body shop and the temperature of the product should be similar. When working with 2K products, it is recommended to use personal protection equipment. Protect the eyes and airways.
• The rooms should be well ventilated.
• Clean the guns and equipment immediately after use.

Caution: To maintain safety, always follow the instructions given in the MSDS for the products.